Diagnóstico B3109, C0277, C0577 en Chevrolet Suburban 2019 5.3L V8
Códigos B3109, C0277, C0577 en Chevrolet Suburban 2019: síntomas, definiciones, causas probables y verificaciones prioritarias documentadas por ChatMecano.
Síntomas observados
Im having trouble with the key fob, the range is very short. Also none of my tire pressures are registered
Códigos OBD2 detectados
- B3109 — Code de défaut diagnostic standard constructeur
- C0277 — Code de défaut diagnostic standard constructeur
- C0577 — Code de défaut diagnostic standard constructeur
Análisis y verificaciones de ChatMecano
Las notas técnicas reproducen el expediente original; algunos extractos pueden conservar el idioma introducido por el usuario.
Key Fob Short Range & TPMS Not Registering
These two issues, key fob range and TPMS sensor registration, are often related to the Remote Control Door Lock Receiver (RCDLR) module.
Likely Diagnosis
- Key Fob Short Range:
- Weak or dead key fob battery.
- Internal key fob damage.
- Radio Frequency (RF) interference.
- Faulty RCDLR module.
- No Tire Pressures Registered:
- Dead or failing TPMS sensor batteries (all four simultaneously is less common but possible).
- TPMS sensors not properly programmed to the vehicle.
- Faulty RCDLR module.
- Wiring issue to the RCDLR.
Given both issues are present, a shared component like the RCDLR module is a strong candidate for a common failure point.
Step-by-Step Procedure
- Check Key Fob Battery:
- Replace the key fob battery in all active fobs. Use a CR2032 coin cell battery.
- Test key fob range after replacement.
- Scan for Diagnostic Trouble Codes (DTCs):
- Connect an OBD-II scan tool.
- Check for codes in the Body Control Module (BCM) and RCDLR module (if accessible as a separate module).
- Look for codes related to RCDLR communication (e.g., B3109 for RCDLR performance) or TPMS (e.g., C0277 for TPMS sensor, C0577 for RCDLR internal fault).
- Perform TPMS Relearn Procedure:
- Ensure all tires are inflated to the placard pressure (38 PSI / 262 kPa).
- Access the TPMS relearn mode via the Driver Information Center (DIC) or using a scan tool.
- Follow the procedure to activate each sensor, starting with the front left, then front right, rear right, and rear left. A TPMS activation tool may be required.
- Verify if pressures register after successful relearn.
- Inspect RCDLR Module (if DTCs point to it):
- The RCDLR module is typically located in the headliner area, near the rear dome lamp, or behind the instrument panel.
- Inspect the module and its connectors for corrosion, damage, or loose connections.
- Check for power and ground at the RCDLR connector according to the FSM wiring diagrams.
- Test TPMS Sensors:
- Use a dedicated TPMS diagnostic tool to individually test each TPMS sensor for signal strength and battery status.
Torques & Specifications
- Key Fob Battery: CR2032.
- Tire Pressure: 38 PSI / 262 kPa (refer to door placard for exact vehicle specification).
OEM Parts / References
- Key Fob Battery: CR2032 type.
- TPMS Sensor: GM Part Number 13598773 (ref to verify).
- RCDLR Module: GM Part Number (varies by vehicle options, requires VIN for exact match, e.g., 84318080 or 84318081 ref to verify).
Common Pitfalls & Known TSBs
- RF Interference: Aftermarket accessories (dash cams, chargers, LED lights) can sometimes cause RF interference affecting key fob and TPMS signals.
- TPMS Relearn Errors: Ensure the correct sequence is followed during relearn. If using the DIC method, the horn chirps confirm successful sensor learning.
- TSB 16-NA-310: Addresses various key fob and RCDLR related issues, including range and programming. While dated, it indicates a history of RCDLR concerns. Review for applicability to your specific VIN.
- TSB 19-NA-087: Addresses TPMS sensor issues in some GM vehicles, including potential sensor battery degradation or programming difficulties. Review for applicability.
- RCDLR Software Update: In some cases, a software update for the RCDLR module via SPS programming may resolve communication issues. This requires a dealer-level scan tool.
Estos ejemplos ayudan a orientar el diagnóstico. No confirman una falla en tu vehículo: verifica las mediciones y especificaciones del fabricante antes de reparar.