Análisis y verificaciones de ChatMecano
Las notas técnicas reproducen el expediente original; algunos extractos pueden conservar el idioma introducido por el usuario.
Regarding the EAT6 transmission issue.
Likely Diagnosis
- Valve Body Malfunction: Common failure point. Solenoid degradation or internal wear causes harsh shifts, delayed engagement, slipping, or gear lockout. Often manifests as issues with 3rd, 4th, or 5th gear.
- Transmission Fluid Degradation/Level: Incorrect fluid level or severely degraded fluid can cause erratic shifting, slipping, overheating, and internal wear. Peugeot specifies AW-1 (Aisin Warner 1) fluid.
- Torque Converter Clutch (TCC) Issues: Can present as shuddering during lock-up, RPM fluctuations, or P0741 DTC.
- Internal Clutch Pack Wear: At 200,000 km, wear on friction plates and steel plates is possible, leading to slipping under load.
Step-by-step Diagnostic Procedure
- Connect diagnostic tool (DiagBox).
- Read all DTCs from Engine ECU and Transmission ECU.
- Check transmission fluid level and condition (color, smell).
- Monitor live data: fluid temperature, solenoid commands, gear commanded vs. actual, TCC slip, line pressure.
- Perform road test: observe shift quality under various loads and speeds, noting any harshness, delays, or slips.
- Check for TCC lock-up operation.
- Perform transmission adaptation reset if components are replaced or fluid changed.
Common Pitfalls & Known TSBs
- Fluid Specification: Using incorrect ATF. EAT6 requires AW-1 (Aisin Warner 1) type fluid. OEM reference: Peugeot/Citroën 9734.R7. Capacity is approximately 6.5 L / 6.9 qt for full refill.
- Fluid Level Check: Precise temperature-dependent procedure. Must be checked with engine running, transmission at specified temperature (typically 58-68°C / 136-154°F), and shifter cycled through all gears.
- Adaptation Reset: Critical after valve body replacement, solenoid replacement, or major transmission work. Failure to perform can result in continued shift quality issues.
- TSBs: Numerous TSBs exist for EAT6 transmissions addressing harsh shifts, delayed engagement, and torque converter shudder. These often involve valve body replacement or software updates. Check DiagBox for available software updates.
Special Tools Required
- Peugeot DiagBox / Lexia diagnostic interface.
- Transmission fluid fill adapter and pump.
- Torque wrench (Nm / lb-ft).
Torques & Specifications
- Specific torque values for transmission pan bolts, valve body bolts, and transmission mounts vary slightly by engine variant.
- Transmission pan bolts: Typically 10-12 Nm / 7-9 lb-ft.
- Valve body bolts: Specific sequence and torque; typically 8-10 Nm / 6-7 lb-ft.
- Crucial: These values require exact engine model confirmation. The stated 1.9L engine is not a standard offering for a 2017 Peugeot with an EAT6.
Differential Diagnostics
- Electrical Faults: Check wiring harness and connectors for damage or corrosion affecting solenoids or sensors.
- Engine Performance Issues: Misfires, low fuel pressure, or turbocharger issues can sometimes mimic transmission problems. Verify engine health before extensive transmission diagnosis.
- Transmission Cooler: Inspect for blockages or leaks.
For precise torque specifications, specific TSBs, and detailed repair procedures, please provide the exact engine code (e.g., EP6FDT, DW10FD) or full model designation.